Controls - GE Profile 42 Série Manuel D'utilisation

About the controls with temperature settings.
NOTE: The refrigerator is shipped with protective film covering the temperature controls.
If this film was not removed during installation, remove it now.
The temperature controls are preset in the factory at 37°F for the refrigerator compartment and 0°F for the freezer
compartment. Allow 24 hours for the temperature to stabilize to the preset recommended settings.
The temperature controls can display both the SET temperature as well as the actual temperature in the refrigerator and
freezer. The actual temperature may vary slightly from the SET temperature based on usage and operating environment.
Changing the Temperature for Non-dispense Models
To change the temperature, press and release the (+) or (-)
pad to the desired temperature set point for fresh food and
freezer separately. Allow 24 hours for the refrigerator to
reach the temperature you have set.
Changing the Temperature for Dispense Models
To change the temperature, press and release the Freezer
or Fridge pad. The display will show the set temperature. To
change the temperature, press either the Freezer or Fridge
pad until the desired temperature is displayed.
4
Dispense Models
Non-dispense Models
To turn OFF cooling system, press and hold either (+) pad
until both displays show OFF.
To turn OFF cooling system, press and hold Fridge and Ice
Maker simultaneously for 3 seconds. When the cooling
system is OFF the display should read OFF.