Table des Matières
Publicité
6-5. Sequence Of Cutting Operation
Connect work clamp to a clean, paint-free
location on workpiece, as close to cutting
area as possible.
!
The pilot arc starts immediately
when trigger is pressed.
Raise trigger lock and press
trigger. Pilot arc starts.
Adjust torch speed so
sparks go thru metal and
out bottom of cut.
OM-272180 Page 18
.
A complete Parts List is available at www.HobartWelders.com
Pause briefly at end of
cut before releasing trigger.
°
90
For extended (non-shielded) cutting, use 1/16 in. (1.6 mm)
standoff distance (dragging tip will reduce tip life).
To maintain a consistent standoff distance, use optional
standoff guide (See Section 6-6).
After cutting arc starts, slowly
start moving torch across metal.
Postflow continues for approx. 20 seconds
after releasing trigger; cutting arc can be
instantly restarted during postflow by raising
trigger lock and pressing trigger.
Ref. 254 087-A
Publicité
Table des Matières
Dépannage
