Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Tightening Torque Setting
EN
EN
See the illustration
1. Open the shutter, (1) in the illustration
with the clutch setting handle, () in the illus-
tration
10
.
Engage the ribs on the main unit with the
ribs on the clutch setting handle (on the
short side) and turn clockwise.
See the illustration
. Insert the 3 ribs on clutch setting handle
(on the long side) into the shutter holes.
User should insert the highlighted wider
rib into the highlighted hole.
To increase clutch torque, turn the clutch
setting handle clockwise. To decrease
clutch torque, turn the clutch setting han-
dle counterclockwise.
See the illustration
3. Close the shutter with the clutch setting
handle (on the short side) by turning coun-
terclockwise.
NOTE
• Be sure to close the shutter after setting
has been completed in order to prevent
dust from entering.
• Illustration
the getting at #0 and #40.
Tightening torque chart (reference
values)
See the illustration
• Refer to the tightening torque chart, in illus-
tration
13
, to select torque settings.
• The values in the chart are just for reference
and measured under the conditions defined
by Panasonic. During actual work, values
will vary based on operating conditions.
Measurement conditions
As defined by Panasonic
All manuals and user guides at all-guides.com
10
11
12
12
is an example of clutch
13
CAUTION:
• Do not use the tool without prior verifi-
cation of its tightening torque setting to
avoid excessive or inadequate torque.
• Always finish rundown with the tool's trig-
ger switch fully depressed. Otherwise, it
10
,
may affect torque accuracy.
Configuring Tool Settings
RPM adjustment setting
1. Turn off the control panel.
• If the control panel is on, remove and
then reinsert the battery pack.
. Depress the switch while pushing the
button and then release both the
ton and the switch.
• After the LED light and tightening con-
firmation lamp have illuminated and the
buzzer has rung, the control panel will
flash and change to configuration mode.
See the illustration
NOTE:
• The control panel will turn off if the tool
is not operated for a period of 5 min-
utes.
See the illustration
3. Press the
clutch setting that is appropriate for the
work being performed.
As the
button
is pressed
78
79
77
RPM
80
800
75
750
45
450
15
150
- 1 -
14
15
and
buttons to select the
As the
button
is pressed
80
15
16
...
17
GA1
GA
GA3
Setting not
available
Setting
available
but-
Publicité
Table des Matières
