Attaching Or Removing Battery Pack - Panasonic EYFGA1AR Instructions D'utilisation

CAUTION:
EN EN
• If the collar does not return to its origi-
nal position or the bit comes out when
pulled on, the bit has not been properly
attached. Make sure the bit is properly
attached before use.
9 mm – 9.5 mm
Attaching or Removing Bat-
tery Pack
1. To connect the battery pack:
Align the highlighted marker points and
attach battery pack.
• Slide the battery pack until it locks into
position.
See the illustration
. To remove the battery pack:
• Push down the highlighted button and
slide the battery pack forward.
See the illustration
IV
O PERATION
.
Before Using the Remote
Control (Available as an
optional accessory)
Insert the battery
1. Pull out the battery holder.
1 Push in on the fastener as indicated by the
arrow.
2 Pull out the holder.
See the illustration
. Insert the battery and push the holder
back in.
See the illustration
NOTE:
• If the tool does not respond to the wire-
less remote control even when the remote
control is operated close to the tool, the
All manuals and user guides at all-guides.com
6.35 mm
1
2
3
4
- 10 -
battery (CR05) is dead. Replace it with
a new battery.
• The included battery is provided for sam-
ple use and may not last as long as com-
mercially available batteries.
Wireless remote control range
See the illustration
The remote control should be operated within
approximately 50 cm and approximately 60°
vertically and horizontally of the perpendicular
relative to the infrared receiver on the tool.
• Under the following circumstances, you may
not be able to operate the tool, even within
this range.
• When an object between the remote con-
trol's transmitter and the tool's receiver.
• When the remote control's transmitter has
been exposed to light.
• When the remote control's transmitter or
tool's receiver are dirty.
[Main Body]
CAUTION:
• If a tool holder is used with the
Panasonic EYF series assembly tools,
make sure the tool's trigger switch
doesn't hit the tool holder. It may run the
tool accidentally and result in battery
failure by unexpected battery discharge.
See the illustration
Forward / Reverse Rotation
Switch operation
See the illustration
1. Push the lever for forward or reverse
rotation. Check the direction of the lever
before using.
. Depress the trigger switch slightly to start
the tool slowly.
3. Speed will increase by pressing the trig-
ger. The tool stops working immediately
by releasing the trigger.
4. When done with an application, lock the
switch by centering the lever.
CAUTION:
• To prevent damage, do not use the for-
ward/reverse lever when tool is in use.
5
6
7