Connecting The Appliance - Acova Z22940 Notice D'utilisation

1.2 Positioning your towel radiator
Min H: 15 cm
EN
IMPORTANT: this towel radiator should never be installed with the power
supply unit positioned topside.
Ensure that the bottom of the towel radiator is positioned at least 15 cm from the
floor.
WARNING: To avoid any danger to very young children, you are advised to
install this towel radiator so that the lowest heating bar is at least 600 mm
above the ground.
NOTE: electric towel radiators are designed to be covered safely. However, to
ensure that your appliance works efficiently, you are advised not to cover it
completely. Doing so will increase the temperature and cause the internal
cutout to turn off the appliance.
20

1.3 Connecting the appliance

The technical specifications of your appliance are shown on the nameplate, which
is located on the side of the appliance towards the bottom. Please take note of
these before installing the appliance.
When connecting the appliance to the mains, you must ensure that:
- voltage and power are as specified on the nameplate
- standard colour coding is used (brown: live, blue or grey: neutral, black: pilot
wire).
The flexible cable supplied with the appliance is designed to be connected to the
mains via a junction box that must be placed behind the appliance, with no need
for a plug. In a kitchen or bathroom, the junction box must be positioned at least
25 cm from the floor.
CAUTION: If the pilot wire is not connected, it must be insulated for safety reasons.
Under no circumstances must it be connected to earth.
1.4 Radiator installation restrictions
This appliance must be installed in accordance with applicable standards and
good practice in the country concerned.
IMPORTANT: the radiator must not be exposed to intensive or on-going ambient
humidity (shower, swimming pool, etc.).
IP: level of protection against
ingress of water
xxxV – xxxxW: voltage and power
required for installation
Appliance reference number
Class II: double insulated
OF: serial number
21
EN