SOLIS CAFFISSIMA IQ Mode D'emploi page 52

All manuals and user guides at all-guides.com
troubleShootInG
▲ ▲
Problem Possible cause
Grinder does
– Grinder not plugged in.
not start
after pressing
– Grinder is overheated.
START/ CAN-
CEL button
– Bean hopper not at-
tached correctly. 'LOCK
BEAN HOPPER' will
be displayed on LCD
screen.
Motor starts
– Incorrect button press.
but no
ground cof-
– No coffee beans in
fee coming
bean hopper.
from grind
outlet
– Grinder/bean hopper
is blocked.
Motor starts – Grinder is blocked with
but operates
foreign item or grind
with a loud
outlet chute is blocked.
'racket' noise
– Moisture clogging
grinder.
Unable to
– Coffee beans obstruct-
lock bean
ing bean hopper lock-
hopper into ing device.
position
52
What to do
– Plug power cord into power
outlet.
– Remove power plug from power
outlet. Leave for 20 minutes to
cool down before using again.
– Lock bean hopper into position
using the locking knob.
– Press START/CANCEL button
or Portafilter Switch to activate.
– Fill bean hopper with fresh
coffee beans.
– Remove bean hopper. Inspect
bean hopper & grind heads for
blockage. Replace parts and try
again.
– Remove bean hopper, inspect
burr & check if a foreign item
is stuck. Remove any foreign
bodies.
– Clean burr heads and chute (refer
to Cleaning & Care instructions).
– Leave burrs to dry thoroughly be-
fore re-assembling. It is possible
to use a hair dryer to blow air
into grinder inlet (lower burr) to
dry faster.
– Remove bean hopper. Clear
coffee beans from top of burrs.
Re-install and re-lock bean hop-
per into position and try again.