Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
With the supplied hexalobular wrench, remove the bolt
near the lubrication marking on the gear case. Loosen
the bolt on the other side so that the air in the gear case
can be released when applying the grease.
After applying the grease, be sure to tighten the bolts.
1
2
► 1. Bolt 2. Gear case
Drive axle:
Apply grease (Makita grease SG No.0) every 25 hours
of operation.
NOTE: Genuine Makita grease may be purchased
from your local Makita dealer.
Interval of inspection and maintenance
Whole unit
All fixing screws and nuts
Rotor blades and protector
Gear case
Drive axle
Power unit
Operating hour
Visually inspect for damaged parts
Tighten
Clean and visually inspect for dam-
aged parts
Supply grease
Supply grease
Refer to the instruction manual of the power unit
Storage
WARNING:
tions in the chapter "SAFETY WARNINGS" and
the instruction manual of the power unit.
When storing the attachment separated from the power
unit, put the cap onto the end of the shaft.
Before
Operation
-
-
-
9 ENGLISH
Follow the warnings and precau-
Daily (10h)
-
-
-
-
25h
-
-
-
Publicité
Table des Matières
