Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
WARNING:
Before assembling or adjusting the
equipment, switch off the motor and remove the spark
plug cap or battery cartridge. Otherwise the cutting tool
or other parts may move and result in serious injury.
WARNING:
Before handling the rotor
blades, wear protective gloves. During the assem-
bly or adjustment, your fingers may contact with the
rotor blade and it may cause serious injury.
WARNING:
When assembling or adjusting
the equipment, always put it down. Assembling or
adjusting the equipment in an upright position may
result in serious injury.
WARNING:
Follow the warnings and precau-
tions in the chapter "SAFETY WARNINGS" and
the instruction manual of the power unit.
Mounting the attachment pipe
CAUTION:
Always check that the attach-
ment pipe is secured after installation. Improper
installation may cause the attachment falling off from
the power unit and cause personal injury.
Mount the attachment pipe to the power unit.
1.
Turn the lever toward the attachment.
► 1. Lever
2.
Align the pin with the arrow mark. Insert the
attachment pipe until the release button pops up. Make
sure that the position line is on the tip of the arrow mark.
► 1. Release button 2. Arrow mark 3. Pin 4. Position line
1
1
2
3
4
3.
Turn the lever toward the power unit.
1
► 1. Lever
Make sure that the surface of the lever is parallel to the
pipe.
NOTICE:
Do not tighten the lever without the
attachment pipe inserted. Otherwise the lever may
tighten the entrance of the drive shaft too much and
damage it.
To remove the pipe, turn the lever toward the attach-
ment and pull the pipe out while pressing down the
release button.
Fig.12
► 1. Release button 2. Lever 3. Pipe
OPERATION
WARNING:
tions in the chapter "SAFETY WARNINGS" and
the instruction manual of the power unit.
WARNING:
shoulder harness to your comfortable position
before operating.
6 ENGLISH
1
2
Follow the warnings and precau-
Adjust the hanger position and
3
Publicité
Table des Matières
