Dremel PawControl 7760-PGK Consignes D'utilisation/De Sécurité page 27

1600A01P55.qxp_7760-PGK 3/8/19 1:19 PM Page 27
contoured surfaces. They are used most
effectively as a finishing sander after
heavier surface sanding and material
removal is completed. Flapwheels come in
fine and coarse grades. Buffs are a great
finishing accessory for cleaning and light
sanding. They work effectively on metal,
glass, wood, aluminum and plastics. Coarse
and medium buffs are sold together. All
buffs are sold individually. Do not exceed
15,000 RPM in speed. 1/8" shank.
Grinding Wheel
Use for deburring, removing rust, and
general purpose grinding. Use with Mandrel
#402.
Brad Point Drill Bits
Titanium coated brad points stay on center
and begin drilling immediately. For use on
wood. Size 1/8", 5/32", 3/16", 1/4", 1/8"
shank.
HSS Drill Bits
HSS drill bit for use in metal and plastic.
Size 1/8", 7/64", 3/32", 5/64", 1/16", 3/64",
1/32". Shank size matches the drill bit size.
Different collet size (481, 482, 483) or
Dremel chuck (4486) required according to
drill bit being used.
Glass Drill Bits
Diamond tipped drill bits for use on glass
and ceramic wall tile. Lubricant included.
Dremel Accessories
Blows dust away for greater visibility to
work piece. Great for sanding, engraving
and carving. Do not use dust blower to stop
or slow down the tool. Do not contact dust
blower with fingers or workpiece during
use.
This chuck allows you to quickly and easily
change accessories on Dremel Rotary Tools
without
accessories with 1/32" - 1/8" shank. Read
instruction manual. Insert and securely
tighten the shank of the accessory well
within the jaws of the chuck.
27
Dust Blower
Dremel Chuck
changing collets.
Do
Dremel chuck
with AT01-PGA pet grooming
attachment. Use only 1/8" collet
and collet nut. Use of the Dremel
chuck may result in damage to the
attachment.
Accepts
not use