Dremel PawControl 7760-PGK Consignes D'utilisation/De Sécurité page 24

1600A01P55.qxp_7760-PGK 3/8/19 1:19 PM Page 24
damage.
Store accessories in a dry and temperate environment to avoid corrosion and
deterioration.
The number and variety of accessories for the Rotary Tool are almost limitless. There is a
category suited to almost any job you might have to do and a variety of sizes and shapes
within each category which en ables you to get the perfect accessory for every need.
If you expect to use a variety of accessories,
we recommend that in the beginning you
purchase a complete set of four collets.
Store these so that you will have the proper
size of collet for any accessory or drill bit
you want to use. Currently, the 1/8",
3/32",1/32"
accommodate all of the avail able Dremel
accessories. 1/8" collets are included in
most rotary tool kits.
MANDRELS
A mandrel is a shank with a threaded or
screw head, which are required when you
use polishing accessories, cutting wheels,
sanding discs, and pol ish ing points. The
reason mandrels are used is that sanding
discs, cutting wheels and similar accesso ries
must be replaced frequently. The mandrel is
a per manent shank, allowing you to replace
only the worn head when necessary, thus
saving the expense of replacing the shaft
each time.
Screw Mandrel No 401
This is a screw mandrel used with the felt
polishing tip and felt polishing wheels. 1/8"
shank.
Small Screw Mandrel No 402
This is a mandrel with a small screw at its
tip, and is used with emery and fiberglass
cutting wheels, sanding discs and polishing
wheels. 1/8" shank.
Dremel Accessories
Use only Dremel®, high-performance accessories. Other accessories are
not designed for this tool and may lead to personal injury or property
COLLETS
and 1/16" collets
EZ Lock Mandrel No 402
The Dremel EZ Lock makes accessory
changes easy as PULL - TWIST - RELEASE.
The one-piece mandrel design simplifies the
process of changing cutting wheels, buffs
and detail abrasive brushes (EZ Lock
compatible accessories).
EZ Drum™ Mandrel No EZ407SA
The Dremel EZ Drum makes accessory
changes easy as PULL - INSERT - PRESS
DOWN. The one-piece mandrel design
simplifies the process of changing sanding
bands.
High Speed Cutters
Available in many shapes, high speed
cutters are used in carving, cutting and
slotting in wood, plastics and soft metals
such as aluminum, copper and brass. These
are the accessories to use for freehand
routing or carving in wood or plastic, and
for precision cutting. Made of high quality
steel. 1/8" shank.
Tungsten Carbide Cutters
These are tough, long-lived cutters for use
on hard ened steel, fired ceramics and other
very hard ma terials. They can be used for
engraving on tools and garden equipment.
1/8" shanks.
24