Dremel PawControl 7760-PGK Consignes D'utilisation/De Sécurité page 16

1600A01P55.qxp_7760-PGK 3/8/19 1:19 PM Page 16
Assembly Instructions for pet nail grooming
30. Release sleeve 30. Sanding disc
32 should lock in place (Fig. 5).
mandrel may lead to personal injury or
property damage. To check for proper
seating, hold shaft lock button 7 and
twist the sanding disc 32. The sanding
disc 32 will not be able to rotate on
mandrel.
▶ To unload sanding disc:
A. Pull spring-loaded sleeve 30 DOWN
toward tool with one hand (Fig. 5).
B. Hold sleeve 30 down while twisting
sanding disc 32 90 degrees (Fig. 5).
C. Remove sanding disc 32 (Fig. 5).
▶ To attach nail guard
attachment:
Note: Make sure that the mandrel and
the sanding disc are mounted properly
before mounting the attachment.
A. Detach the clear cap 21 from the
attachment by running the small
knobs 25 on the inside of the clear
cap up along the height adjustment
guide 26 until they reach the guided
opening (Fig. 6).
B. Unlock the clasp 22.
C. Open the attachment 20 (Fig. 6).
D. Position the attachment 20 around
the threaded nose of the tool 12 and
close the attachment together until
the clasp 22 is fully engaged (Fig. 7).
E. Turn the whole attachment 20
clockwise to screw it into place on
the threaded nose 12. Make sure that
it is securely tightened so that it will
not shift positions during use (Fig. 7).
F. Re-attach the clear cap 21 (simply
perform step A in reverse order).
G. Turn the clear cap so that the small
knobs are all the way to the end of
slot 26 (next to number "3") on the
attachment. You will hear the cap
click into place when fully installed.
Do not force the clear cap out of the
guides (Fig. 6).
Incorrect seating of
sanding disc on
Fig. 6
21
26
Fig. 7
20
D
Note: Refer to the AT01-PGA manual on
the Dremel website for additional
information regarding attachment
compatibility.
16
A
25
B
22
20
C
E
22
12