Hisense HMN544ISF Livret D'instructions page 39

9
the bottom feet may need to be adjusted.
You can adjust them manually by hand or
by using a suitable spanner.
To allow the doors to self-close, tilt the
top backwards by 10-15 mm.
Whenever you want to move the
appliance, remember to turn the feet back
up, so that the appliance can roll freely.
Reinstall the appliance when relocating.
Doors removal
In case when your access door is too
narrow for the refrigerator to pass through,
remove the refrigerator door and drawers.
Then pass the refrigerator laterally. If you
do not need to remove the appliance
doors, go to 'Installing the water lines' on
page 11.If you need to remove the doors,
continue below.
Warning!
When reversing the door, the appliance
must be unplugged.
The tools you will need (Not provided):
Allen Wrench(4mm)
Philips screwdriver
Disassembling the fridge door
Some models may be slightly different
from pictures. If some parts shown in the
picture cannot found in your appliance,
please ignore the relevant description.
1. With the door closed, remove the 3
screws holding the top cover (A) with
Philips (+) screwdriver, and then remove
the top cover carefully
entire-harnesses unattached.
2.Take out connectors and the water
coupler from the
Remove the two wire connectors (press
the top of the connector (B) and separate
it from the other one) on the left side
door .To remove the water coupler from
the hinge, twist and pull the clips from the
coupler then remove the water line (C)
while pressing the movable part (D) of the
water line coupler.
Wrench(8mm)
with the
installation clip.