Axis Communications P5522-E Guide D'installation page 17

AXIS P5522–E PTZ Dome Network Camera
1
Screw
2
Slots for unit holders
3
Safety wire
4. Connect the network cable to the camera.
5. Slide the unit holders on the network camera into the slots in the mounting bracket and
rotate the camera unit.
6. Secure the network camera to the mounting bracket by tightening the screws.
Install the Midspan
The supplied midspan enables Axis network video products with high power consumption to receive
data and power over the same network cable.
1. Connect the midspan (data in) to the network switch using a network cable.
2. Connect the midspan (data and power out) to the camera using the network cable that
has been connected to the camera.
3. Connect the midspan to a grounded (earthed) mains power outlet (100–240 V AC) using
the supplied power cable.
3
17
1
2