Axis Communications P5522-E Guide D'installation page 16

AXIS P5522–E PTZ Dome Network Camera
5. Put the top cover back in its original position and fasten the screws (torque 2.5 to 3.0
Nm).
Install an SD Card
NO NO TICE NO TICE TICE
To prevent corruption of recordings, the SD card should be unmounted before it is ejected.
To unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
It is optional to install a standard or high capacity SD card (not included), which can be used for
local recording with removable storage.
See Hardware Overview on page 10 for location of components.
1. Remove the sunshield.
2. Loosen all of the top cover screws and remove the top cover.
3. Insert an SD card (not included) into the SD card slot.
4. Put the top cover back in its original position and fasten the screws (torque 2.5 to 3.0
Nm).
5. Put the sunshield back in its original position and fasten the screws.
Install the Camera on a Bracket Mount (sold separately)
NO TICE TICE
NO NO TICE
To comply with the IP66-rated design of the camera and maintain the IP66 protection,
the supplied RJ45 Push-pull Connector (IP66) shall be used. Alternatively, use the RJ45
IP66-rated cable with premounted connector which is available from your Axis reseller. Do
not remove the plastic network connector shield from the camera.
1. Install the selected bracket according to the instructions supplied with the bracket. If
drilling is required, make sure to use drill bits, screws and plugs that are appropriate for
the material.
2. Connect supplied RJ45 Push-pull Connector (IP66) to the network cable according to the
instructions supplied with the connector.
3. Secure the camera using the supplied safety wire.
16