Blaupunkt Memphis MP66 Notice D'emploi Et De Montage page 55

Switching the internal amplifi er
on/off ( Internal Amp)
If you connected the device to an
external power amplifi er via the
preamplifi er outputs (Preamp),
you can switch off the internal
amplifi er of the device as follows:
CAUTION!
No sound with switched-
off internal amplifi er!
If you switch off the internal am-
plifi er, you do not hear a sound
from the loudspeakers connected
to the device!
➔
Switch off the internal ampli-
fi er only if you connected an
external power amplifi er to the
preamplifi er outputs (Preamp)
of the device and you connect-
ed your loudspeakers to this
power amplifi er:
➔
Press the softkey
"Internal Amp").
The status of the internal am-
plifi er is displayed:
•
: The internal amplifi er
is switched on. Loudspeak-
ers connected to the device
play back the selected audio
source.
•
: The internal amplifi er is
switched off. Loudspeakers
connected to the device al-
ways remain mute. The loud-
All manuals and user guides at all-guides.com
Changing basic settings in the settings menu
Resetting the device to factory
settings ( Norm Set)
➔
➔
8
Changing the scan time
(next to
( Scan Time)
➔
➔
➔
speakers must be connected
to the external amplifi er.
Press the softkey
"Norm Set").
The "Norm Set" menu appears.
Press and hold the softkey
for approx. two seconds.
"NORMSET ON" briefl y appears
on the display. The device is
reset to the factory settings.
Images and animations, which
you transferred to the device,
are deleted.
Note:
To exit the "Norm Set" menu
without resetting the device to
the factory settings, press the
A
OK button or the ESC but-
@
ton .
Press the softkey
"Scan Time").
The current scan time is dis-
played.
On the rocker switch
peatedly press
crease the scan time.
On the rocker switch
peatedly press
crease the scan time.
<
(next to
<
;
(next to
3
, re-
or to in-
3
, re-
or to de-
55