Martec RMD 03 Manuel Utilisateur page 29

4.3.1. RECV Menu (reception)
When the RMD 03 is first powered up, the RECV mode is selected and the data are displayed just
after the initial reception.
(1) Reception and display of ARGOS message
The last two received beacons are displayed on the LCD screen, each one identified by lines
of 16-characters, the most recent being displayed on the upper line.
I D N
I D N
IDNUMER : Identification of beacon number
Displayed in hexadecimal or decimal, a * sign on the right of the number
indicating a possibility that the received beacon be encoded with a 28-bits ID
code.
L- : Information on the number of lost bits
0 for none;
1 for 1 to 10 bits lost;
2 for 11 to 20 bits lost, etc.,
9 for more than100
LR : Level received, from 0 to 99
T1 : Time elapsed since the last reception
T2 : Time elapsed between two receptions
(2) Selection of beacon and display of sensor data
- To select the beacon, use the SELECTION function.
- «S» is displayed at the right of the ID number.
- To delete this selection, use the SELECTION function.
To display the sensor data of the selected beacon, use the SHIFT function (press the
pushbutton once):
I D N
N : Number of sensor groups displayed
M : Number of sensor groups for which data are displayed
D : Sensor data
Pressing the pushbutton again displays the next groups.
(3) Display of beacon with special decoding
See para 6. ANNEXES
DOC05198A
U M E R
U M E R
U M E R
N / M :
ARGOS RECEIVER RMD 03
L L R
L L R
L L R
D D D D D
USER MANUAL
T 1
T 2
T 1
D D
PAGE : 21