Esoteric Grandioso P1X Mode D'emploi page 29

The main unit does not respond when buttons are pressed.
e Multiple button presses without pause can cause the main unit
to not respond . After pressing a button, wait momentarily for
the main unit to respond .
There is noise.
e Place the main and power supply units as far away as possible
from TVs and other devices that have strong magnetism .
No sound is output from the speakers. The sound is distorted.
e Check the connections with the D/A converter(s), the amp and
the speakers (page 10) .
e Change the digital output setting to match the connectors that
are being used (page 25) .
e Adjust the volume of the amplifier and other devices .
e If the disc is dirty, wipe it clean (page 9) .
e No sound is output when playback is paused . Press the play
(t) button to resume ordinary playback .
The digital audio of a Super Audio CD cannot be output.
e In order to output the digital audio of a Super Audio CD, you
must use an ESOTERIC D/A converter (Grandioso D1X, D-02X,
D-05X, Grandioso D1, D-02, D-05, D-03 or D-01) .
The CLOCK indicator continues blinking and does not stay lit
normally.
e If a clock signal is not being input, set the clock (CLK>) to OFF
(page 26) .
e A clock signal that is not 10MHZ might be being input . Check the
connection of the CLOCK 10MHz IN connector and the settings
of the connected devices .
"CLOCK!" appears on the display.
e There is a problem with the clock setting or a connection .
See "Clock setting" on page 26 about the clock setting and
"Connections (main unit)" on page 10 about connections .
o Synchronization with a stable external clock could take a
minute or even longer .
Since the Grandioso P1X uses a microcontroller, external noise
and other interference can cause it to malfunction. If this
occurs, turn the product off once, and then restart it after wait-
ing for about one minute.
Note about condensation
If this product is brought from a cold outdoor environment into
a warm room, or the heater has just been turned on in the room
where it is located, for example, condensation might occur on
operating parts or lenses, resulting in improper operation . If this
occurs, leave the product on and wait one to two hours . This
should enable normal playback .
29