Aqua Marina PURE AIR PA AK-01P Guide De L'utilisateur page 8

NOTE:
INFLATE THE KAYAK
Inflate the side chambers and air floor in sequence as shown in
the picture on P7.
1. Attach the pump hose to the pump and secure it tightly.
2. HIGH PRESSURE VALVE (FOR PA-AK01P/02P/03P)
Unscrew the valve cap, push button in and turn it
clockwise to make sure that the valve is in the
"Pin Out" position.
BOSTON VLAVE (FOR PA-AK04P)
Ensure that the main valve is securely screwed
into the ring plate first.
Open the upper cap of the Boston valve for
inflation.
In this situation, the valve only lets air in, not out.
3. Start pumping air into the kayak. Keep inflating
until the required air pressure is reached. DO NOT OVERFILL. Once inflated, firmly cap
each valve.
TIP: If the pump piston starts to squeak, apply some lubrication oil on the piston shaft.
TIP: Working pressure of each part should NOT exceed the maximum.
NOTE：After multiple times of inflation – deflation, there may be slight displacement of
the valve. Replace it to the correct position when the kayak is deflated. Then inflate to
required air pressure to use.
PARTIALLY INFLATE THE SIDE CHAMBERS AND THE KAYAK FLOOR
AND CHECK THAT THE FLOOR IS TUCKED UNDERNEATH THE SIDES.
FOR DEFLATION ONLY
Step 1
8
Step 2
Main valve
Ring plate
BOSTON VALVE
Upper cap