Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MANUFACTURER'S RECOMMENDATION
The total number of persons and total weight shall not exceed the limits printed on the kayak.
Please refer to the kayak's hull label for the actual specifications of your product.
KAYAK LABEL FORMAT
1. Standard: EN ISO 6185 PART 1 TYPE
BS EN ISO 6185 PART1 TYPE III
2. Country of origin
3. Maximum passengers
4. Manufacturer's recommended maximum load capacity
5. Manufacturer's recommended working pressure
6. Hull identification number (HIN)
7. Manufacturer's name and address
1
EN ISO 6185 PART1 TYPE Ⅲ
BS EN ISO 6185 PART1 TYPE Ⅲ
Do not over inflate or use high pressure air compressor to inflate.
Inflate the chambers in numbered sequence.
Use the enclosed barometer to check while inflating.
Ensure even distribution of persons or loads in the KAYAK.
WARNING:
This is not a life saving device.
Use only under competent supervision.
Always use an approved life preserver.
Do not use in high wind, rapid currents, open water or dangerous tides.
Be familiar with area where you intended to use KAYAK.
Never allow diving into this product.
Never leave in or near the water when not in use.
Follow these rules to avoid drowning, paralysis or other serious injury:
- Not for use by children without adult supervison.
- Do not overload.
- Know and follow local water safety rules and regulations.
MADE IN CHINA
2
Ⅲ
PA-AK01P
DATE
STANDARD
BOAT TYPE
DESIGN CATEGORY
BOAT MODEL
=
CN-ORP
ORIENTAL RECREATIONAL
PRODUCTS (SHANGHAI) CO.,LTD
NO. 1699 DAYE ROAD,
WUQIAO, FENGXIAN,
SHANGHAI, 201402, CHINA
7
3
3
EN ISO 6185-1:2018
BS EN ISO 6185-1:2018
TYPE Ⅲ (B)
/
PA-AK01P
= 1
= 0
+
= 95KG (209lbs)
0.1bar / 1.45psi
0.3bar / 4.35psi
(DWF Deck)
5
6
4
Publicité
Table des Matières
