Reset To Factory Default Settings - Axis Communications P5512-E PTZ Guide D'installation

AXIS P5512–E PTZ Dome Network Camera
1
Screw
2
Slots for unit holders
3
Safety wire
4. Connect the network cable to the camera.
5. Slide the unit holders on the network camera into the slots in the mounting bracket and
rotate the camera unit.
6. Secure the network camera to the mounting bracket by tightening the screws.
Access the Product
Use the tools provided on the Installation and Management Software CD to assign an IP address,
set the password and access the video stream. This information is also available from the support
pages on www.axis.com/techsup/

Reset to Factory Default Settings

Important
Reset to factory default should be used with caution. A reset to factory default will reset
all settings, including the IP address, to the factory default values.
Note
The installation and management software tools are available on the CD supplied with the
product and from the support pages on www.axis.com/techsup
To reset the product to the factory default settings:
3
16
1
2