Opus Technologies LD Serie Manuel D'installation Et D'utilisation page 13

LD Series | Installation and user manual
4.5.3 Rack-mounting two loop amplifiers
Required accessory: OP-R* mounting kit
Attach the rack mounting brackets as shown below
(Figure 8) using the mounting screws provided in the kit.
Then attach the amplifiers to each other with the
mountingbrackets.
Finally, integrate the amplifier into the rack.
Note: The OP-R mounting kit is not supplied with the
one-channel amplifiers (LD1.0, LD2.0 and LD3.0) of the
LD series.
Illustration of 2 amplifiers integrated
User manual
4.5.4 Mounting the loop amplifier on a wall
Required accessory: OP-R* mounting kit
Attach the mounting brackets as shown below (Figure 9)
using the screws provided in the kit.
Then, attach the amplifier to the selected wall.
in a rack - Figure 8
*The OP-R mounting kit is not supplied with the
one-channel amplifiers (LD1.0, LD2.0 and LD3.0)
of the LD series.
Illustration of an amplifier integration
on a wall - Figure 9
13