Installation And Connections; Installation Of The Unit - Pioneer PDP-507CMX Mode D'emploi

Installation and Connections

Installation of the unit

Installation using the optional PIONEER stand or
other mounting brackets
÷ Please be sure to request installation or mounting of this unit
by an installation specialist or the dealer where purchased.
CAUTION
÷ Use only those stands or mounting brackets designated by
Pioneer. If other non-recommended products are used, the
unit may fall and be damaged or otherwise malfunction.
÷ Assemble stands or mounting brackets correctly in accordance
with the instructions provided or other applicable installation
instructions.
÷ Two or more people should always work together when
installing or removing this unit.
÷ The installation location selected should be fully capable of
supporting the weight of this unit, and be a stable, flat, and
even surface. If installed in other locations, the unit may fall or
be damage.
÷ After installation, take appropriate measures to prevent the
installation from falling. The failure to take such measures
could allow the unit to fall, causing injuries or damage.
Wall-mount installation of the unit
This unit has been designed with bolt holes for
wall-mount installation, etc. The installation holes
provided are shown in the accompanying illustration.
÷ Be sure to attach in 4 or more locations above and
below, left and right of the center line.
÷ Use bolts that are long enough to be inserted 12 mm
1 11
( / in.) to 18 mm ( / in.) into the main unit from the
2 16
attaching surface for both a holes and b holes. Refer to
the side view diagram in the accompanying illustration.
÷ As this unit is constructed with glass, be sure to install
it on a flat, unwarped surface.
CAUTION
When this unit is installed on a wall, the work should be done by
a professional technician possessing the requisite technical
knowledge and abilities; consult your dealer for more
information. Improper or insufficient installation may result in
accidents, damage or personal injury.
CAUTION
÷ Handles should not be removed or reattached by anyone other
than the professional installation technician or service
personnel.
÷ When moving the display, it should always be carried by two
persons holding the rear handles in the manner shown.
Never attempt to move the Plasma Display by holding only
one of the handles.
11
En