INFOSEC UPS SYSTEM E3 Serie Notice D'utilisation page 3

3 . S A F E T Y I N S T R U C T I O N S – S e c u r i t y
SAVE THESE INSTRUCTIONS - This Manual Contains Important Instructions that
should be followed during Installation and Maintenance of the UPS and Batteries.
WARNING: Do not attempt to repair or service this UPS. It manages high voltages which
could cause and run the risk of electrical shock. Even if this UPS is disconnected from
the electrical mains power, there may still be potentially dangerous voltage via the
battery. All maintenance and battery replacement should be performed by qualified
service personnel only.
1. This UPS should be set up in a room with adequate airflow and free of
contamination. Install or operate it in a clean and indoor environment, free from
moisture, flammable liquids, and direct sunlight. Ambient temperature range must be
between 0°C and 40°C (32°F to 104°F).
2. This UPS is designed for Commercial/Industrial use only. It is not intended for use
with life support systems or other designated "life-critical" medical devices.
3. Do not remove the input power cord when this UPS is turned on. This deactivates
the safety ground link and the equipment connected to the UPS.
4. Turn off the UPS and disconnect the input power cord before proceeding to replace
the battery.
5. Battery contains high short-circuit current. Replacing or servicing the battery should
be performed and supervised by qualified service personnel aware of the required
precautions.
• Remove watches and jewelry
• Use tools with insulated handles
• Wear rubber gloves and boots.
• Do not lay tools or metal parts on top of batteries.
• Disconnect charging source prior to connecting or disconnecting battery
terminals.
6. When replacing the batteries, use the appropriate replacement battery kits: it is
compulsory to use of same number and type of battery.
7. Do not open or damage the battery in any way. Released electrolyte may be toxic
and harmful to skin and eyes.
8. Do not dispose of the battery in a fire. It may explode. Proper disposal of the battery
is required. Please refer to your local laws and regulations for disposal requirements.
9. To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line
cord.
10. This UPS manages high voltages. Do not run the risk of electric shock by removing
the cover. There are no user replaceable parts inside this UPS. Please contact your
local dealer or distributor for any maintenance operations.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière – 44700 Orvault – FRANCE - www.infosec.fr
Hot Line : tel : + 33 (0)2 40 76 15 82 - fax : + 33 (0)2 40 94 29 51 - hotline@infosec.fr - 09 05 04 205 12
All manuals and user guides at all-guides.com
3