INFOSEC UPS SYSTEM E3 Serie Notice D'utilisation page 14

7 . I N S T A L L A T I O N A N D O P E R A T I O N
1. Inspecting the Equipment
Inspect the UPS upon receipt. If the UPS has been damaged during shipment, notify the
carrier and dealer immediately
2. Position
This UPS should be installed in a room with adequate airflow and free of contamination.
Locate it in a clean and indoors environment, free from moisture, flammable liquids, and
direct sunlight. Maintain a minimum clearance of 4 inches (100mm); the ambient
temperature must be between 0°C and 40°C (32°F to 104°F), and relative humidity
between 20% and 80% (non-condensing).
CAUTION: The long term use at an ambient temperature in excess of 25°C would reduce
battery life. In addition, place the UPS unit at least 20cm away from the monitor to avoid
interference.
3. Charging
This UPS is shipped from the factory with its internal battery fully charged; however, some
charge may be lost during shipping. The battery should be recharged prior to use. Plug the
UPS into an appropriate power supply and allow the UPS to charge for at least 4 hours.
4. Load Connection
Connect one load-related device to each of the power receptacles supplied at the rear of
the UPS.
5. Modem/Phone line Connection
Plug the incoming telephone line into the "In" socket at the back of the UPS. Use on
telephone line cable and plug one end of the telephone line cable into the "Out" socket at
the back of the UPS. Plug the other end into the modem input socket.
6. DC Start Function
DC Start Function enables the UPS to be started up when AC utility power is not available
(if the battery is full charged). Simply press the On/Off switch to turn on the UPS.
7. Turn On/Off
To turn on/off the UPS, press and hold the on/off switch for at least three seconds.
8. UPS Setup
All model series are designed for use in a tower or rack. They can be installed as a 19-inch
equipment rack, and the 3000VA can be placed in a tower (with optional stand) as well.
Please follow the instructions for Tower Setup or Rack-Mount Setup.
9. Tower Setup
This series can be placed horizontally and vertically. The 3000VA model is designed in a
rack itself. As a tower, it is provided with UPS stand to stabilize the UPS when it is
positioned vertically. The UPS stand must be attached to the bottom of the tower.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière – 44700 Orvault – FRANCE - www.infosec.fr
14
Hot Line : tel : + 33 (0)2 40 76 15 82 - fax : + 33 (0)2 40 94 29 51 - hotline@infosec.fr - 09 05 04 205 12
All manuals and user guides at all-guides.com