Aerian CO2TIMER Manuel D'utilisation page 6

OPERATION
The heater carries a symbol
exists if the heater is accidentally covered.
When using your heater for the first time, it is normal for the heater to
1. Place the heater on a flat, dry and clean floor.
Ÿ Position the heater upright on the floor, at least 1 m away from the wall, away from curtains,
furniture or wall coverings.
2. Plug in the heater.
3. Touch to turn on the heater.
4. Temperature setting :
Repeatedly touch
Anti-frost function
When the temperature reaches 10°C, touch
the display will show
The appliance keeps the room at a temperature of 7°C to avoid freezing.
5. Power setting :
Repeatedly touch
The display will show the corresponding indicator.
Low power
6. Timer setting :
Touch and hold
While the number "0" is flashing, repeatedly touch
hours).
The selected time number will flash for about 3 seconds and then stop flashing, indicating the
setting is confirmed.
The display will show the remaining working time and when the set time has elapsed, the heater
will enter the standby state.
7. Brightness of the display
The default brightness is 100%.
'DO NOT COVER' to alert the user to the risk of overheating that
emit a 'new heater' smell, which will disappear after a while.
Ensure good ventilation.
Œ
Press this power switch.
You will hear a beep.
or to set the desired temperature from 10°C to 35°C.
.
to set the low or high power setting.
1250W
for about 3 seconds until the display shows "0h".
once, the anti-frost function will be activated and
or to set the time (1/2/3/4/5/6/7/8/9
EN-5

The standby button will
be displayed.
High power
2000W