Aqua Medic Ocean Light T5 Mode D'emploi page 8

4. Installation
The light can be fastened on the aquarium edge with the attached plastic holders or alternatively
with the steel cable at the ceiling.
4.1 Fixing by using the plastic holders
The plastic holders consist of the following different parts:
2 holders incl. hinge (1). These are slid into the rear bar of the light.
-
2 small holders (2.1). These are slid into the front bar of the light.
-
2 supports (2.2). These are attached to the aquarium edge.
-
For assembling, the holders (1) are pushed onto the light in such a way that they can be put on the
aquarium edge. The holders (2.1) and (2.2) are aligned in such a way at the light and/or at the
aquarium that they interlink, if the light is folded down. The holders are shifted that way that the
light rests upon the aquarium symmetrically. Now, the positions at the aquarium edge can be
marked. Then, the holders are taken off the aquarium and glued on the markings by using
Aquaseal. Now, they can be fixed by the Allen screws. After the Aquaseal has dried, the light can
simply be folded in and out for maintenance of the aquarium.
Important: It is absolutely necessary to glue the holders on for safety reasons!
4.2 Suspension by using the steel cable
The cable suspension system provides a neat and simple method of ceiling mounting of Ocean
Light T5 or other suitable lights.
Contents:
The suspension system comprises 2 pcs. of each of the following:
1. ceiling plate with screws and plugs, 2 metre stainless steel cable with stopper
2. light fixing (cable with Y-piece, end bushes and screws)
8