Evolution 063-0001 Manuel D'instructions page 11

www.evolutionpowertools.com
Fig. 1
Fig. 2
Fig. 3
B B
A
Fig. 4
OPERATION
1. Replacing/changing a Sanding Belt
WARNING: Always ensure that the machine is disconnected
from its power source before attempting to change or replace
the sanding belt.
• Pull the belt release lever from the RH side of the machine.
(Fig. 1)
• Slide out the belt to be replaced.
• Refit the required belt over the two rollers. (Fig. 2)
Note: Always ensure that the direction of rotation arrows found
on the inside of the belt match the direction of rotation arrow
found on the body of the machine. (Fig. 3)
• Return the belt release lever to its original position.
2. Centering the Sanding Belt
WARNING: Wear eye protection when attempting to centre the
sanding belt.
• Turn the machine upside down so that you have a clear view
of the belt.
• Start the motor and observe the position the belt adopts
after a few seconds of running at full speed.
If the sanding belt is not running centrally in the machine turn
the belt tracking control knob a little in either direction until
central tracking is achieved. (Fig. 4a)
Only turn the tracking control knob by a few degrees at a
time before observing the position of the belt relative to the
machines sole plate. (Fig. 4b)
11
EN