Connecting Additional Modules To The »Ibell; Troubleshooting - HumanTechnik iBell Mode D'emploi

Masquer les pouces Voir aussi pour iBell:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The transmitters register the »iBell« signal and convert it into a radio signal.
These wireless radio signals are transmitted to the according receivers, which
then indicate the event.
Please note: Devices of the alerting system »lisa RF« cannot be combined
with devices of the alerting system »signolux«.
Sensitivity adjustment of »lisa RF telephone transmitter acoustic« and
»signolux Acoustic Universal Transmitter«
Set the sensitivity control of the according transmitter to the highest setting
(turn clockwise until limit). The transmitter will now react upon the vibration
alarm of the mobile phone.
Connecting additional modules to the »iBell«
Signal emitter modules (vibrating pillow, flash
module MF-1, acoustic module MA-1 or switch
module MS-1) can be connected with the
»iBell« via its lateral connection jack.
Plug one end of the supplied lead in the »iBell's«
connector jack and the other end of the lead in
the module's connection jack.
Battery life
Battery endurance my vary strongly, according to the quality of the bat-
teries purchased.
Under normal conditions, a set of new batteries should last approx. 6 months
and more.
18 English
BA_IBell_2015.indd 18-19
All manuals and user guides at all-guides.com
»iBell«
Vibrating
pillow

Troubleshooting

Symptoms
The »iBell« does not blink when
a call/text message has been
received.
»iBell« blinks although no call/text
message has been received.
The red LED at the top right is
constantly blinking.
I have connected the »iBell« with
a wireless Humantechnik alerting
system, but it is not triggering.
Possible causes/remedy
Check whether the batteries have
been inserted correctly and are ful-
ly charged.
Check whether the longest and
strongest vibration alarm has been
set on your mobile phone.
The device is very close to a strong
wireless signal.
Press the reset button and put the
mobile phone back in the housing.
The device was placed on an une-
ven or vibrating surface (e.g. workt-
op with kitchen equipment).
The mobile phone was not placed
in the housing carefully.
Battery indicator:
Insert new batteries.
Ensure that the »iBell« is connected
to an „acoustic" transmitter. Ensure
that all the leads are connected
properly. Adjust the sensitivity to
the highest setting.
English 19
06.05.2015 10:32:01

Publicité

Table des Matières
loading

Table des Matières