Midwest Critter Nation 163 Instructions De Montage page 3

6.
Lay the Top Panel Grid on the top of the assembled Cage. Line up
the panel so the pegs in the corner line up with the openings in the
corners of the assembled cage. To secure the Top Panel, swing the
Swivel Lock around the wire of the Top Panel till tight in place. It may
be easier to open doors and swing Swivel Lock from side of cage.
Open the doors by pinching the knobs on the doors together. Once
Swivel Lock is in place, tighten Flat Head Screw.
7.
Insert the Middle Pan (E) in the upper unit. Be sure the cut-out is
positioned to match the opening in the Middle Panel Grid Floor.
Note: The Shelves, in conjunction with the Side Panels, can be
positioned at 3 different levels on either side of the cage.
8.
Locate one Shelf (F). With the doors in the top unit open, tilt the
Shelf down and insert the end of the hook in the middle holes on the
right side of the top unit. Lift the Shelf up and let hook fall into place.
9.
Install a Ramp (G) that will allow access from one level to the next.
Attach the hooks on the end of the ramp to the back wire in the
opening of the Middle Panel Grid. (If needed, remove the shelf from
the unit below before installing the ramp.)
10.
This ramp has the ability to be secured in the "up" position to section
off the top level from the bottom level. Before inserting the Shelf in
the bottom unit, swing this ramp up and hook it with the attached "S"
hook.
Reinstall Shelf in lower unit as in Step 9.
11.
Attach the Ramp Clips to the shelf ramp by inserting the two hooks
on the ramp into the holes on the Ramp Clips. The hooks on the ramp
and the hooks on the Ramp Clips should be facing the same
direction.
12.
Attach the Ramps to the Shelves by hooking the Ramp Clips to the
wire on the Shelf as illustrated. The lip of the plastic Shelf pan will
cover the Ramp Clips.
6
8
9
11 10
12
Shelf
Side
Panel
Attach Ramp Clips
to Shelf Wire