Midwest Critter Nation 163 Instructions De Montage page 2

assembly InstructIons
1. Remove the Top Panel Grid from the existing cage. Set the Top
Panel Grid aside for use later.
2. Locate the Door Panel (A) and insert the pegs into the outer-most
holes of the Base Assembly. The Door Panel should be inserted
on the side of the stand that has the two locking casters. Be sure
the door locking knobs face outward.
3. Locate the Middle Floor Panel Grid (D) and insert the protruding
wires into the corresponding holes of the Door Panel. Orientate
the panel so the opening is either in the back-right or front left of
the cage.
4.
Locate the Back Panel (B) and insert one peg in one of the back,
outer-most holes. Be sure the protruding rectangular openings
are facing inward. While slightly lifting the Middle Floor Panel
Grid, swing the other end of the back panel around, aligning the
protruding wires of the Grid with the holes in the Back Panel.
When they are all lined up and inserted, put the peg in the outer-
most hole.
5.
Locate the remaining two Side Panels (C), two Swivel Locks (I),
and two Flat Head Screws (H). Using the Phillips Head Screw-
driver (J) and flat head screws attach one Swivel Lock to each of
the Side Panels. (Do not tighten all the way). Attach the Side Pan-
els by inserting the pegs into the holes between the Door and
Back Panels. Be sure the cut-outs on the bottom go around the
protruding wires of the Bottom Floor Panel Grid. Insert the
protruding tabs at the top of the panels into the protruding
openings in the Door and Back Panels to lock the panels together.
1
4
3
5
2