Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
m
WARNING!
Before performing any maintenance, always
disconnect the power supply to the unit and wait until the tine
cylinder comes to a complete stop. Wear protective gloves
when handling the tines.
1. Remove the thatch collection bag.
2. Place the machine upside down on a flat stable surface to
access the underbody.
3. Loosen the two bolts with a suitable wrench, remove them
together with the spring washers and the attached cutting
device (Fig. 14).
Fig. 14
Cutting device
(scarifying cylinder)
4. To remove the cutting device, first lift the bearing and then
pull it out from the drive shaft.
5. Align and insert the respective cutting device: Slide the
hex nut into the socket of the drive shaft and fix the
bearing to the support with the bolts and spring washers
(Fig. 15).
Fig. 15
m
(raking cylinder) is inserted properly. Make sure the semi-circle
of the cylinder goes downward into the unit. If the semi-circle
is face up, it has been inserted incorrectly.
Fig. 16
2 bolts +
spring washers
NOTE: If you have any questions, please call the Snow Joe
+ Sun Joe
(1-866-SNOWJOE) for assistance.
After Use
1. Switch the machine off, disconnect it from the power
2. Check, clean and store the machine as described below.
Thatch Collection Bag
1. Inspect the thatch collection bag before each use. Do not
2. Clean the thatch collection bag after operation. Let the
Transportation
1. Switch the product off and disconnect it from power
2. Attach transportation guards, if applicable.
3. Adjust the cutting depth to the transportation stage (refer
4. Always transport the product by its handle.
5. Protect the product from any heavy impact or strong
6. Secure the product to prevent it from slipping or falling over.
Cutting device
(raking cylinder)
12
WARNING!
Make sure the cutting device
Cutting device
(raking cylinder)
customer service center at 1-866-766-9563
®
supply and let it cool down.
use it if you find any damage.
thatch collection bag dry thoroughly before storing to
avoid mildew.
supply before transporting it anywhere.
to "CUTTING DEPTH ADJUSTMENT" on page 9).
vibrations which may occur during transportation in
vehicles.
semi-circle
®
Publicité
Table des Matières
