NEC LCD19WV Manuel Utilisateur page 4

Power Button
Figure C.1
Non-abrasive surface
Figure R.1
4 x 12 mm with lock washer and flat washer
12 mm
M4
100 mm
100 mm
Specifications
4-SCREWS (M4)
(MAX depth: 8.5 mm)
Weight of LCD assembly: 4.2 kg (MAX) - (LCD19WV)
01_English
All manuals and user guides at all-guides.com
5. Turn on the monitor with the front power button and the computer
6. No-touch Auto Adjust automatically adjusts the monitor to optimal
Figure TS.1
NOTE:
Tilt
Grasp both sides of the monitor screen with your hands and adjust
the tilt as desired (Figure TS.1).
Remove Monitor Stand for Mounting
To prepare the monitor for alternative mounting purposes:
1. Disconnect all cables.
2. Place monitor face down on a non-abrasive surface (Figure R.1).
Figure R.2
3. Remove the 3 screws connecting the monitor to the stand and
4. Connect the AC cord to the back of the monitor (Figure R.2).
5. Reverse this process to re-attach stand.
NOTE:
Thickness of Bracket
(Arm) 2.0 ~ 3.2 mm
NOTE:
Removing the Base
NOTE:
Tighten all screws
1. Place monitor face down on a non-
2. While using your thumbs, press the
3. Press the top tabs down to unlock
Connecting a Flexible Arm
This LCD monitor is designed for use with a flexible arm.
Please use the attached screws (4pcs) as shown in the picture when
installing. To meet the safety requirements, the monitor must be
mounted to an arm which guaranties the necessary stability under
consideration of the weight of the monitor.
The LCD monitor shall only be used with an approved arm
(e.g. GS mark).
5.0 kg (MAX) - (LCD22WV)
English-2
2
(Figure C.1).
settings upon initial setup for most timings.
For further adjustments, use the following OSD controls:
• Image Setup
• Image Position
Refer to the Controls section of this User's Manual for a full
description of these OSD controls.
If you have any problem, please refer to the
Troubleshooting section (CD-ROM).
remove the stand as indicated (Figure R.1).
The monitor is now ready for mounting in an alternative manner.
Use only VESA-compatible alternative mounting method.
Handle with care when removing monitor stand.
Always remove the Base when shipping the LCD.
abrasive surface (Figure R.1).
bottom tabs upward to unlock.
and pull off the stand.
24/9/07, 5:06 PM
Tab