HP 55 Mode D'emploi page 15

side1.fm Page 9 Wednesday, August 4, 1999 4:58 PM
DECLARATION OF CONFORMITY
According to ISO/IEC Guide 22 and CEN/CENELEC 45014
M M M M a a a a nu nu nu nuf f f f a a a a c c c c t t t t u u u u r r r r e e e e r r r r ' ' ' ' s s s s N N N N a a a a m m m m e e e e : : : :
M M M M a a a a nu nu nu nuf f f f a a a a c c c c t t t t u u u u r r r r e e e e r r r r ' ' ' ' s s s s A A A A dd dd dd ddr r r r e e e e s s s s s s s s : : : :
d d d d e e e e c c c c l l l l a a a a r r r r e e e e s s s s , , , , t t t t h h h h a a a a t t t t t t t t h h h h e e e e p p p p r r r r o o o o du du du duc c c c t t t t : : : :
P P P P r r r r odu oduc c c c t t t t N N N N a a a a m m m m e e e e : : : :
odu odu
M M M M od od od ode e e e l l l l N N N N u u u u m m m m b b b b e e e e r r r r : : : :
conforms to the following product specifications:
S S S S A A A A F F F F E E E E T T T T Y Y Y Y - - - - International: IEC 60950:1991 + A1 + A2 +A3 +A4 / GB4943-1995
- Europe: EN 60950:1992 + A1 + A2+A3 + A4
E E E E M M M M C C C C - - - - CISPR 22:1993+A1 + A2 / EN 55022:1994 + A1 +A2 Class B
- EN 50082-1:1992
IEC 801-2:1992 / prEN 55024-2:1992 - 4kV CD, 8 kV AD
IEC 801-3:1984 - 3V/m
IEC 801-4:1988 / prEN 55024-4:1992 - 1 kV Power Lines
- IEC 555-2:1982 + A1:1985 / EN 60555-2:1987
- IEC 61000-3-3:1994 / EN 61000-3-3:1995
- GB9254-1988
- FCC Title 47 CFR, Part 15 Class B
- ICES-003, Issue 2
- VCCI-B
- AS/NZ 3548:1992
Supplementary information: The product herewith complies with the requirements of the following Directives and carries the CE-marking
accordingly:
EMC Directive 89/336/EEC and the Low Voltage Directive 73/23/EEC, both amended by the Directive 93/68/EEC.
1)
The product was tested in a typical configuration with Hewlett-Packard Personal Computer Systems.
2)
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Grenoble, 5 October 1999
For Compliance Information ONLY, contact:
USA contact: Hewlett Packard Company, Corporate Product Regulations Manager, 3000 Hanover Street, Palo Alto, CA 94304. (Phone
(415) 857-1501)
All manuals and user guides at all-guides.com
H H H H E E E E W W W W L L L L E E E E T T T T T T T T - - - - P P P P A A A A C C C C K K K K AR AR AR ARD D D D F F F F r r r r a a a a n n n n c c c c e e e e
5, Avenue Raymond Chanas - EYBENS
38053 GRENOBLE CEDEX 09
FRANCE
HP 15" Color Monitor
D8894A
1)
2)
Jean Marc JULIA
Quality Manager
Notice for the USA: FCC Statement
Federal Communications Commission (FCC) Radio
Frequency Interference Statement (USA Only)
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protections against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try one of more of the
following measures:
•
Relocate the radio or television antenna.
•
Move the computer away from the radio or television.
•
Plug the computer into a different electrical outlet, so that the computer and the
radio or television are on separate electrical circuits.
•
Make sure that all your peripheral devices are also FCC Class B certified.
•
Make sure you use only shielded cables to connect peripheral devices to your
computer.
•
Consult your computer dealer, Hewlett-Packard, or an experienced radio/television
technician for help.
Hewlett-Packard's system certification tests were conducted with HP-supported
peripheral devices and HP shielded cables, such as those you received with your
system. Cables used with this Equipment must be properly shielded to comply with
the requirements of the FCC.
Changes or modifications not expressly approved by Hewlett-Packard could void the
user's authority to operate the equipment.
S S S S a a a a f f f f e e e e t t t t y y y y W W W W a a a a r r r r n n n n i i i i n n n n g g g g f f f f o o o o r r r r U U U U S S S S A A A A
If the power cord is not supplied with your monitor, select the proper power cord
according to your national electric safety codes.
USA: use a UL Listed Type SVT or Type SJT detachable power cord.
N N N N o o o o t t t t i i i i c c c c e e e e f f f f o o o o r r r r J J J J a a a a p p p p a a a a n n n n