Alarm Set; Activating The Alarm; Display Brightness - Daewoo International DCR-440 Manuel D'instructions

CLOCK and ALARM CLOCK OPERATION
Note: The time and alarm times can only be set when the radio is turned o .
TIME SET
1. The digits will ash after connecting power to the radio, or press and hold
down "MEMORY TIME SET" button (1) for approximately 3 seconds until the
display ashes.
2. Press "HOUR / TUN-" button (4) repeatedly to change the hour setting.
3. Press "MIN / TUN+" button (5) repeatedly to change the minute setting.
4. Press "MEMORY TIME SET" button (1) to con rm the time.

ALARM SET

This clock radio has dual alarms that can be set and used simultaneously and
the procedures are the same. Both alarms can either sound the buzzer or wake
up to radio.
Follow the instructions below to set alarm time 1. For alarm time 2, substitute
"AL1/VOL-" button (2) with "AL2/VOL+" button (3).
1. Press "AL1/VOL-" button (2) to view alarm time 1. The digits will ash.
2. Press "HOUR / TUN-" button (4) repeatedly to change the hour setting.
3. Press "MIN / TUN+" button (5) repeatedly to change the minute setting.
4. Press "AL1/VOL-" button (2) once to con rm and digits will stop ashing.

ACTIVATING THE ALARM

1. Once the alarm time is set, press "AL1/VOL-" button (2) once for alarm with
buzzer (Indicator A will be
on) and twice for alarm with radio (Indicator B will be on).
2. Digits will stop ashing after a short while.
3. Press "AL1/VOL-" button (2) until all indicators o to turn o alarm.
4. When the alarm/radio sounds, press "
"SNOOZE SLEEP / DIMMER" button (7) for 9-minute snooze.

DISPLAY BRIGHTNESS

When the radio is o and the current time showing, press and hold "SNOOZE
SLEEP / DIMMER" button (7) to change the brightness of the display between
high and low.
EN
" button (6) to turn alarm o or press
8