Honeywell WV4460E Instructions D'installation page 6

WV4460E POWER VENT WATER HEATER CONTROLS
ON/OFF SWITCH
APPLY WRENCH
HERE WHEN
CONNECTING
SUPPLY LINE
Fig. 7. Water heater controls.
Wiring
Follow the wiring instructions furnished by the appliance
manufacturer, if available, or use the general instructions
provided below. When these instructions differ from the
appliance manufacturer, follow the appliance
manufacturer instructions.
NOTE: All wiring must comply with applicable elec-
trical codes and ordinances.
WARNING
Electrical Shock Hazard.
Can cause severe injury, death, or property
damage.
Disconnect power supply before making wiring
connections to prevent electrical shock or equipment
damage.
Do NOT run the Control without the spark wire
installed and in place.
1. Place the Control's ON/OFF switch in the OFF
position.
NOTE: Use Fig. 8 as a reference for the following
connections.
2. Connect the temperature sensor (Sensor 1 and Sen-
sor 2) to the water heater control.
3. Connect the earth ground to the Control.
4. Connect the 5-wire electrical harness to the Con-
trol.
69-1872EF—01
BLUE LED
SPARK CONNECTOR
(TO PILOT ASSEMBLY Q3451J)
ENVIRACOM
CONNECTOR
TEMPERATURE
SETPOINT KNOB
OUTLET
PRESSURE TAP
M24212B
Fill Tank
NOTE: Be sure to fill the tank before firing the
Turn on Main Burner
Follow the instructions provided by the appliance
manufacturer or turn the Control's ON/OFF switch to the
ON position then adjust the temperature using the
setpoint knob.
6
5. Connect the 2-wire flammable vapor sensor (TOD
FVS) to the Control.
6. Connect the Pilot Assembly lead to the Spark con-
nector.
EARTH
GROUND
5-PIN CONTROL
CIRCUIT CONNECTOR
Fig. 8. Wiring connections.
1. Refer to the appliance manufacturer instructions to
fill the tank with water.
burner.
CAUTION
Dry Tank Hazard.
Can cause the device to malfunction.
The tank must have water in it before turning on the
control.
WARNING
Scalding Hazard.
Can cause burns, severe injury, or death.
Never move setpoint knob past the B setting unless
extremely hot water is desired. Always check water
temperature at the faucet and readjust until
comfortably warm to the touch. Consider the ages
and health of all who will come into contact with
heated water.
3-PIN ENVIRACOM
CONNECTOR
1
SENS GND
SENS 1
FVS
SENS 2
PS
IND 3-PIN WELL
L2 SENSOR
L1
CONNECTOR
2-PIN FVS CONNECTOR
(TO TOD FLAMMABLE
VAPOR SENSOR)
M24215B
2
3