Fisher-Price POWER WHEELS Barbie N3460 Guide De L'utilisateur page 24

Masquer les pouces Voir aussi pour POWER WHEELS Barbie N3460:

Guide de l'utilisateur (20 pages)

Table des Matières

IMPORTANT! If you experience a problem with your vehicle, please contact Power Wheels

PROBLEM

Vehicle does not run

Vehicle was running but

suddenly stopped

All manuals and user guides at all-guides.com

e PROBLEMS AND SOLUTIONS GUIDE

POSSIBLE CAUSE

Undercharged battery

Charger is not working

Tripped thermal fuse

Loose wire or loose connectors

Dead battery

Electrical switch damage

Motor damage

Loose wire or loose connectors

Tripped thermal fuse

Consumer Relations.

SOLUTION

Charge the battery. A new battery should have been charged for

at least 18 hours before using the vehicle for the first time. After

first-time use, recharge the battery for at least 14 hours after

each use. Never charge the battery longer than 30 hours.

Check all connectors. Make sure the battery connector is tightly

plugged into the charger connector, and that the charger is plugged

into the wall.

Make sure power flow to the wall outlet is "ON".

There is no sure way to tell if your charger is working unless you

have a volt meter. If you suspect there is a problem with your

charger, contact Power Wheels

Consumer Relations.

The built-in thermal fuse may "trip" and shut down operation of

the vehicle if the vehicle is overloaded or the driving conditions

too severe. Once a fuse has "tripped", release the button on

the handlebar and wait 25 seconds before operating the vehicle

again. To avoid repeated automatic shutdowns, do not overload

the vehicle by exceeding the 18 kg maximum weight capacity or

by towing anything behind the vehicle. Do not drive up hills or run

into fixed objects, which can cause the wheels to stop spinning

while power is still being supplied to the motors. If a thermal fuse

continually trips, contact Power Wheels

Check all wires and connectors. Make sure the battery connector is

tightly plugged into the motor connector, and that there are no loose

wires around the motors.

If your battery is old or if you have not followed Battery Care

instructions, your battery may be dead. If you are unsure

whether or not the battery is dead, contact Power Wheels

Consumer Relations.

The electrical switches can become corroded due to exposure to

water or moisture, or can jam due to loose dirt, sand or gravel.

Contact Power Wheels