ELRO PRO PV40-P2M2 Mode D'emploi page 19

DVR
FRAME RATE
SCREEN RESOLUTION
MOTION DETECTION
START TIME
END TIME
RECORDING LOCATION
SCREENSAVER TIME
SCREENSAVER - MOTION
- 19 -
Enable/disable DVR function
Set the number of frames per second (5 - 10 -
15 - 20 – 25). More frames per second means
a higher streaming quality of recorded
videos.
Set the screen resolution of video recordings
(640x480, 1280x720, 1920x1080). A higher
screen resolution means sharper video
quality.
Set the motion detector's sensitivity (off -
low - medium - high). This setting determines
at which degree of motion the camera starts
recording.
Set at what time the DVR function switches
on.
Set at what time the DVR function switches
off.
Set to door 1.
On = The screen displays the time when the
DVR function is active and when the screen is
in standby mode.
Off = The screen is in standby mode only
when the DVR function is active. Nothing is
displayed on the monitor.
On = When the DVR function is enabled, the
monitor switches on if motion is detected. In
this case you can tell what caused motion
detection to be activated.
Off = The screen remains black when the
DVR function is enabled and if motion is
detected.