Frequently Asked Questions (Faq) - ELRO PRO PV40-P2M2 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Door 2: Ringtone selection
Intercome 1: Ringtone selection
Repeat incoming-call ringtone
Night mode: 22:00 - 07:00

Frequently asked questions (FAQ)

-
How can I use a door lock release to release the door?
You can do this by pressing in the lower right corner of the screen during an incoming call or
at any other time.
-
How do I change the volume of the bel push?
The volume of the bell push can be changed by removing the small cap on the back of the bell
push.
Does the camera have a motion detection sensor?
-
Yes, the camera has a motion detection sensor that enables automatic video recording. See
chapter Motion Detection Recording.
-
The sound quality is bad or there is no sound at all.
Try to link the cables again and make sure you are using the indicated colours.
-
The monitor remains blank.
Try to link the wires again. Check the power supply if this does not resolve the issue. Only use the
included power adapter. Using an extension cable might cause low power resulting in poor
functioning of the product.
-
Is the outdoor unit waterproof?
The outdoor unit is water and dust resistant and is suitable for any type of weather. The bell push
has an IP value of IP66.
-
Can I connect the PV40 to an app?
It is not possible to connect the PV40 to an app.
- 21 -
Set the ringtone that is played when
someone rings at door 2.
This setting adjusts the sound during a call
between the monitors.
Set if you want the ringtone to be repeated
during an unanswered call.
Enable or disable night mode. This mode
automatically lowers the ringtone volume to
the set volume between 22:00 and 07:00.
00 = Off
05 = Maximum volume

Publicité

Chapitres

Table des Matières
loading

Table des Matières