Troubleshooting & Faq - GN Netcom Jabra WAVE Mode D'emploi

once you have "paired" your headset with two phones simply
make sure your headset is on, and that Bluetooth® is enabled
on the phones and the headset will then automatically connect to
both phones .
Please note:
- Last number redial will dial the number from the phone where
you last made an outgoing call, so not necessarily from the phone
you last used .
- the Voice Dialling function will only work on the last paired
mobile phone . In other words you should make sure to pair
your primary phone last .
TROUBLESHOOTING & FAQ
I hear crackling noises
- Bluetooth® is a radio technology, which means it is sensitive to
objects between the headset and the connected device . It is
designed for the headset and the connected device to be used
within 10 meters (33 feet) of each other, with no major objects
in the way (walls, etc .) .
I cannot hear anything in my headset
- Increase the volume in the headset .
- Ensure that the headset is paired to a device that is playing .
- Make sure your phone is connected to the headset by tapping
the answer/End button .
I am having pairing problems
- You may have deleted your headset pairing connection in your
mobile phone . Follow the pairing instructions .
I want to reset the headset
It is possible to reset the headset . turn the headset on . then 'Press
and hold' the volume down and answer/end buttons at the same
time for approx . 5 seconds until the battery icon and Bluetooth®
icon flash 5 times simultaneously - then the pairing list is reset .
- turn the headset oFF . the next time you power on, the headset
will go into pairing mode as the first time you powered your
new Jabra WaVE on .
Jabra WaVE
9