Ball Valve - ubbink Mamba Mode D'emploi

1 Operating Instruction for Stainless Steel Waterfalls MAMBA / MAMBA LED / MAMBA S LED / BRIDIE LED
Installation
Swimming pool with sand filter system
1.) Pool with wood pool edge
• Place the waterfall element at the selected place on the wood pool edge of your swimming pool.
• Ensure that the hose connection for the waterfall element can be connected without problem to the existing water return from the filter to the pool.
• Then prepare the waterfall element for connection with the water return system according to figure 1.
• Use the base plate for marking the drill-holes for the screws, cut-out for hose and LED-lighting cable (MAMBA LED/MAMBA S LED/BIRDIE LED). See figures 2a, 2b and 2c. Pay
attention to the position and wall thickness of the wood construction of your swimming pool.
• You can then rigidly install the waterfall element on the wood pool edge and connect the hose with the supplied screws and nuts. See figures 2d and 2e.
• For MAMBA LED/MAMBA S LED/BIRDIE LED: Check the LED-strip for correct fit, install the lighting cable outside the swimming pool and connect it to the safety transformer.
• Check the whole water circuit again for leaks. Leaking screwed or hose connections must be sealed with commercially available Teflon-tape.
• Set the water flow as follows before starting the waterfall:

Ball valve

Waterfall ornament
Water return pool
• You can now switch on the pump and LED-lighting (MAMBA LED/MAMBA S LED/BIRDIE LED) and start your waterfall.
2.) Other pool edges
The installation on a pool edge made of another material is possible (e.g. plastic, concrete). The fastening material (dowels, screws) is not included in the delivery volume.
Garden pond
• Place the waterfall element at the location at the garden pond edge you selected.
• Ensure that the installation is carried out on solid ground with sufficient space under the waterfall element for connecting and installing the hose.
• Use the base plate for marking the holes for the screws, hose and LED-lighting cable, if the waterfall element is to be installed on a stone or concrete plate.
• Then prepare the waterfall element for connection to the pump. Use the supplied accessories for this (hose, nipple and ball valve).
• You can place and align the waterfall element at the pond edge after this connecting work. Dowels and screws for fastening on a stone or concrete plate are not included in the
delivery volume.
• For MAMBA LED/MAMBA S LED/BIRDIE LED: Check the LED-strip for correct fit, install the lighting cable outside the garden pond and connect it with the safety transformer.
• Check the whole water circuit again for leaks. Leaking connections should be sealed with commercially available Teflon-tape.
• You can then switch on the pump and LED-lighting (MAMBA LED/MAMBA S LED/BIRDIE LED) and start your waterfall.
• Should the water outlet at the waterfall element be too strong, this can be regulated and adjusted by using the ball valve included in the delivery volume.
Replacing bulbs (MAMBA LED/MAMBA S LED/BIRDIE LED)
Please proceed as follows when replacing the LED-strip:
Remove the cable seal (rubber) at the bottom of the waterfall element.
Open the fastening clips on the left and right of the waterfall outlet. Remove the LED-strip and pull out the lighting cable.
Push a solid wire (approximately 1 m) upwards through the lower cable opening, hook the cable plug to this and then pull out the wire downward.
Then pull the cable, insert the LED-strip and close the clips on the left and right.
Feed the lighting cable into the cable seal and re-attach the rubber seal solidly.
Replacement of single defective LED-diodes is not possible. The LED-lighting concerned must be removed and replaced as one unit.
Waterfall ON
Open (ON)
Closed (OFF)
Waterfall OFF
Closed (OFF)
Open (ON)