Installing The Grille - Paradigm OM-110 Manuel Du Propriétaire

INSTALLATION INTO EXISTING WALLS OR CEILINGS (continued)
2. Connecting and Installing
You are now ready to connect and install the speaker. If you are color-match painting your
speakers do so now before proceeding. Follow painting instructions provided earlier.
Connecting (all speakers except models with 'SM' in their name, see below)
Place complete assembly to the wall or ceiling and connect the speaker cable. Correct polarity,
or phase is critical for proper stereo imaging and bass performance.
Connect the red (+) amplifier terminal to the red (+) speaker terminal. Connect the black (-)
amplifier terminal to the black (-) speaker terminal. Fasten cable to bracket with wire tie .
Connecting 'SM' Models
Stereo Input (Single Speaker) (Fig. 6a): Connect one speaker channel at a time to your receiver/amplifier.
Connect the Right red (+) amplifier terminal to the Right red (+) speaker terminal and the Right
black (-) amplifier terminal to the Right black (-) speaker terminal. Connect the Left red (+) amplifier
terminal to the Left red (+) speaker terminal and the Left black (-) amplifier terminal to the Left
black (-) speaker terminal.
Mono Input (Fig. 6b): Connect one speaker at a time to the left and right channels of your
receiver/amplifier. First, convert the Right speaker to Mono: Using a short piece of cable, connect
the Right red (+) speaker terminal to the Left red (+) speaker terminal and the Right black (-) speaker
terminal to the Left black (-) amplifier terminal. Then ...
Connect the Right red (+) amplifier terminal to the Right red (+) speaker terminal and the Right
black (-) amplifier terminal to the Right black (-) speaker terminal.
Repeat the entire procedure for Left speaker.
Installing
Confirm the Series that your speaker belongs to, then follow the appropriate directions below:
CS Series Speakers (Rectangular and round)
1) Holding the speaker's front lip with your thumbs and index fingers push the mounting
screws toward each other with your other fingers so that the mounting brackets fit through
the hole. (Fig. 4a)
2) Release the screws and gently push the speaker to the wall/ceiling. (Fig. 4a)
Models with Guided Soundfield™ : Rotate speaker at this point so that drive assembly
points in the desired direction (not shown) .
3) While holding the speaker in place, alternately tighten each screw until speaker is firmly
installed. (Fig. 4b)
PV Series Speakers (Rectangular and round)
1) Gently push the speaker assembly through the hole until only the flange is visible. (Fig. 5a)
2) While holding the speaker in place, alternately tighten each screw. The tightening action
will automatically release hidden spring clamps on the rear designed to hold the speaker
firmly in place. (Fig. 5b)

3. Installing the Grille

Press the grille into the groove on the front face of the speaker.
5