Maintenance And Cleaning; Repair; Taking Out Of Service - Franke Frames FH FS 784 Manuel D'utilisation

EN
To avoid damaging the appliance
In the case of thermal failure, switch the solid
Z X
plate off and allow to cool down completely. Do
not put any dishes on it. Do not cool with cold
water under any circumstances.
Do not climb onto the appliance.
Z X
To avoid damaging the silicon grouting, do not put
Z X
hot cookware on the frame.
Do not cut or prepare food on the surface or drop
Z X
hard objects onto it. Do not drag cookware across
the surface.
Make sure than no sugary foods or juices end up
Z X
on the hot cooking zones. This can damage the
surface. If sugary foods or juices do end up on
the hot cooking zones, remove these immediately
with a glass ceramic hob scraper (while the hob is
still hot).
Do not leave the appliance unattended during
Z X
operation.
Pots with pure copper or aluminium leave behind
traces that can be difficult to clean. If the traces
are not removed immediately after cooking with a
suitable cleaning agent, they can be permanently
burned on and therefore permanently ruin the visual
appearance of the appliance.
Do not use pots with pure copper or aluminium
Z X
bases for cooking.
Sliding pots and cookware across the glass ceramic
causes scratches.
Avoid scratches by lifting pots and cookware
Z X
when putting them into place.
The hob is an item for daily use: signs of usage
such as scratches or visible material abrasion from
pots or cookware are normal. Intensive use leads
to more distinctive signs of usage. In such cases,
the appliance continues to function perfectly
and a complaint is not justified. Safety is always
guaranteed.
FH FS 784 / FH FS 584

Maintenance and cleaning

Do not use coarse abrasive materials or sharp metal
Z X
scrapers to clean the glass parts of the appliance, as
they could scratch the surface and cause the glass
to shatter.
Do not use steam cleaners or direct jets of water.
Z X
Risk of electric shock due to entering
liquid!
The device contains electrical components.
Make sure that no liquid enters the interior of the
Z X
device.
Do not use pressurised steam to clean the device
Z X

Repair

The appliance is manufactured in compliance with
the relevant effective safety standards.
Do not allow anyone except qualified personnel to
Z X
install or repair the appliance.
Contact a service centre authorised by the
Z X
manufacturer or qualified personnel in the
following cases:
– Immediately after unpacking, in the event of doubts
regarding the integrity of the device
– During installation (according to the
manufacturer's instructions)
– Doubts regarding the correct operation of the
device
– Malfunction or poor operation
– Replacing the power socket if incompatible with
the power plug of the device
– Damage to the power cable or need of replacing
the power cord or plug
Use original spare parts only.
Z X

Taking out of service

If the appliance is no longer to be used, call the
Z X
service centre or qualified personnel to disconnect
it from the power supply.
– 8 –
.