Replacing The Lamp - Electrolux SB318N Notice D'utilisation

All manuals and user guides at all-guides.com
Problem
The compressor does not
start immediately after
pressing the Shopping-
Mode, or after changing
the temperature.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be
set.
DEMO appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Possible cause
This is normal, no error
has occurred.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The FastFreeze or Shop-
pingMode function is
switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The FastFreeze function is
switched on.
The ShoppingMode func-
tion is switched on.

6.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
ENGLISH
Solution
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off FastFreeze or
ShoppingMode manually, or
wait until the function resets
automatically to set the tem-
perature. Refer to "Fast-
Freeze or ShoppingMode
function".
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
Set a higher/lower tempera-
ture.
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Refer to "FastFreeze func-
tion".
Refer to "ShoppingMode
function".
57