Hand Control - Handicare RisePorto450 Manuel D'utilisation

Hand control

Connection of hand control to lift unit
The outlet for the hand control (1) is on the short side of the lift. Connect the hand
control firmly.
1
Raising/lowering
The buttons with the black arrows (2) raise and lower the lift unit. Motion stops as soon
as the button is released. The lift unit can also be activated with the buttons for raising/
lowering.
On/off via hand control
The hand control is equipped with a green button (ON) to activate the lift unit and a
button (OFF) to shut it off (3). The lift unit automatically shuts off after 15 minutes of
2
inactivity. Normally, the lift can be activated via the green (ON) button before use.
Activate/start the lift unit
The lift unit is activated by pressing the green button (ON) or the Up- or Down-button
on the hand control. When this is done the battery symbol on the lift unit´s information
display is lit for 2 seconds, showing the current battery status. If the battery symbol
does not light and the lift unit is not activated, check that the emergency stop is not
activated (pressed in).
3
Active safety
ON OFF
RisePorto has a built-in slack strap switch requiring that, in order to be
manoeuvered up or down, RisePorto must be loaded with at least 2 kg or its own
weight. This is a safety feature that prevents a slack lift strap from being winded in or
out from the lift unit causing a short fall when next in use.
RisePorto automatically stops if the lift strap is unloaded, for example if it is lowered
onto a table. If this happens, the lift strap must be manually stretched in order to be
manoeuvered up or down.
If the lift strap is twisted when lifting upwards, the lift unit automatically stops and can
only be manoeuvred down.
In order to save battery the lift unit automatically turns off after 15 minutes of inactivity.
SystemRoMedic 11
M A N U A L
TM