Electrical Emergency Lowering; Manual Emergency Lowering/Raising - Handicare RisePorto450 Manuel D'utilisation

Electrical emergency lowering

If the hand control does not function, electrical emergency lowering can
be done in two ways: Alternative 1, by pressing the down arrow on the lift
units information display. Alternative 2, by pressing the emergency stop
button to its most inner position and holding it there until the user is at an
appropriate height.
Emergency lowering should take place only if no other
electrical function works.
When using the electrical emergency lowering special attention must be
taken to the lift´s motion. Lower the user down to safe height and not any
further.
Resetting: The emergency stop button automatically goes back to
emergency stop mode as soon as it is released. After evaluation of the
situation the emergency stop may be deactivated by pulling the button
outwards until an audio signal is heard.
Always ensure that emergency lowering takes place in an appro-priate
location.

Manual emergency lowering/raising

Place the emergency lowering key supplied with the lift unit into the hole.
Turn the key counterclockwise for lowering until the user is at an
appropriate height.
NOTE!
The manual emergency lowering requires numerous rotations.
Trouble-shooting
If the lift cannot be activated, check that:
- the emergency stop button is not pushed in.
- all cables are properly and securely connected.
- battery charging is not in progress.
- the battery is charged.
- the lift strap is loaded.
If the lift unit is not working properly, contact your dealer.
If the lift makes unusual noises:
- Try to determine the source of the sound. Take the lift out of operation and contact your dealer.
SystemRoMedic
M A N U A L
TM
1
2
13