Cembre B68M-P18 Notice D'utilisation Et Entretien page 14

(*) Screens 1-2-5-6-7-9 can be set as the "main screen" which is shown
on the display at every use of the pump; to do this, when the pre-
selected screen is displayed, hold the fi nger on the button (13) until
a confi rmation "beep" is heard.
4.2) Choosing the "operating mode"
The "operating mode" allows the user to set the pump depending on the type of hydraulic head
connected; this enables the optimisation of the job cycle and charging of the battery.
It is possible to choose between three diff erent operating modes:
CRIMPING
Operating
mode
CRIMPING
factory setting
CUTTING
PUNCHING
To change the desired "operating mode", proceed as follows:
- Select screen 3 from the "main menu" (Ref. to § 4.1).
- Hold the finger on the button (13) until a confirmation "beep" is heard, the choice made is shown
by filling of the related pictogram.
Associated
pictogram
Specifi cally for using the pump with hydraulic heads (max. 230
kN) for crimping of electrical connectors.
Specifi cally for using the pump with hydraulic heads for cutting
electrical conductors and steel ropes.
Specifi cally for using the pump with frame type hole punching
hydraulic heads or piercing hydraulic heads.
BEEP
CUTTING
Function
BEEP
BEEP
PUNCHING
14