Cutting Operation - Cembre B68M-P18 Notice D'utilisation Et Entretien

CUTTING OPERATION

Press the start button: this activates the motor of the pump that feeds the
hydraulic head connected to it, pressurising the oil. Keep the button pressed
until the cutting operation is complete. At the end of the cycle the display
will show the maximum pressure reached (P
At the end of the cycle, proceed with the phase of returning the oil to the
pump reservoir (Ref. to § 3.5 for further details).
PUNCHING OPERATION
Press the start button: this activates the motor of the pump that feeds the
hydraulic head connected to it, pressurising the oil. Keep the button pressed
until the punching operation is complete. At the end of the cycle the display
will show the maximum pressure reached (P
At the end of the cycle, proceed with the phase of returning the oil to the
pump reservoir (Ref. to § 3.5 for further details).
3.5) Oil release
The phase of returning the oil to the pump reservoir, or rather to the re-entry of the ram of the
connected hydraulic head, may be carried out in two diff erent ways depending on the release
mode set (Ref. to § 4.3 for further details):
With the remote controller:
- smart mode: release the start button (following automatic shut-off of the motor).
- manual mode: press the release button.
With the rocker switch on the pump (only if the remote controller is
disconnected):
- smart mode: release the control button at the end of the cycle.
- manual mode: push the control button backwards.
If required, by pressing hard on the mechanical pressure
release button (6), the oil will return to the reservoir whatever
the status of the battery.
).
p
).
p
P = 0 bar
P = 325 bar
p
P = 0 bar
P = 547 bar
p
6
12