MINN KOTA MKA-51 Mode D'emploi page 5

6
l. Replace the four sideplate screws using a #3
Phillips screwdriver. Two of these screws will be
located on each side of the mount.
m. Reassemble the Top Plate and Motor to the
Bottom Plate so that the plates are flush as
described in the first position in the Mounting
Considerations and secure with the Cam Lever
and Pin.
6m
Top Plate
Pin
Cam Lever
7
n. Place the mount with the Electric Steer Quick
Release Bracket attached as close to the center
line or keel of the boat as possible. The motor
can be installed on either the Port or Starboard
side of the boat based on personal preference.
Check placement with the motor in the stowed
and deployed positions. Review the mounting
considerations at the beginning of the installation.
o. When the motor is in the deployed position, make
sure that the Shaft is 1-1/2" out past the Gunwale
of the boat. The lower unit, when stowed and
deployed must not encounter any obstructions.
p. When checking clearance, make sure to check
for obstructions for the plate and motor when
they are in all possible positions. The plate moves
sideways approximately 1-1/2" and also slides
back 6 inches. This allows the motor to be moved
for trailering, transport or a boat cover without
being removed. With this movement, make sure
to check for additional obstructions such as a
windshield or lights.
7p
Possible
Need New Illustration
Position of
Top Plate
©2017 Johnson Outdoors Marine Electronics, Inc.
6l
Bottom Plate
7n
7o
Outboard
Bow of
Boat
Inboard
Sideplate Screw
Gunwale
NOTE:
Make sure that the motor will not encounter
any obstructions when sliding the motor on and off
the quick release bracket. The exact placement of the
motor and Electric Steer Quick Release Bracket when
mounting may vary depending on the boat, boat deck,
and which base extrusion or bracket the quick release
bracket is being mounted to. The Ulterra motor cannot
be deployed before mounting and connecting a power
source.
Keel
Deck of Boat
1-1/2"
Minimum
Shaft
minnkotamotors.com | 5