Publicité
Les langues disponibles
Les langues disponibles
4
ITEM(S) NEEDED
#4 x 6
h. Place the flat side of the Top Plate against the
bottom of the Base Extrusion. Align the Mounting
Holes in the Top Plate with the Mounting Holes
in the Base Extrusion that were exposed when
the sideplates were removed. Make sure that
the Cam Lever is located on the mount closest to
the Power Cord. The appearance of your Base
Extrusion may vary depending on motor type.
i.
Use six each of the 1/4-20 X 7/8 Screw (Item
#4), 9/32 X 5/8 X 1/16 Flat Washer (Item
#10) and 1/4-20 Nylock Nuts (item # 6) to
secure the Top Plate to the Base Extrusion. It
is recommended to use a minimum of two bolts
on each side, placing them the farthest apart
on the mount. The screws will pass from the
bottom up, through the Top Plate and then the
Base Extrusion. The Flat Washers are placed
on the screws on top of the Base Extrusion, and
then secured with the Nylock Nuts. Tighten the
Nylock Nuts with the 7/16" Box End or Open End
Wrench. Make sure all hardware is secure.
NOTE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may
help prevent seizing.
5
j.
After the Top Plate is secured to the Base
Extrusion, replace the Right Sideplate.
k. Swing the Left Sideplate back into its correct
position on the Base Extrusion.
5k
©2017 Johnson Outdoors Marine Electronics, Inc.
#10 x 6
#6 x 6
Right Sideplate
Nylock Nuts
Flat Washer
Base Extrusion
Power Cord
Exits Here
Top Plate
Inboard
Mounting
Holes
NOTE:
If you are mounting an Ulterra to the Electric
Steer Quick Release Bracket, the Clipped Washers
that were previously used to install the motor to the
boat, or included in the mounting hardware that came
with the Ulterra motor should be used. Place the
Clipped Washer above the Base Extrusion, between
the Base Extrusion and the Nylock Nut. Refer to the
Ulterra Owner's Manual online at
com
for complete details on mounting the Ulterra.
5l
Base Extrusion
Left Sideplate
Outboard
Mounting
Holes
Screw
minnkotamotors.
minnkotamotors.com | 4
Publicité
