Publicité
Les langues disponibles
Les langues disponibles
2
c. Remove the four sideplate screws using a #3
Phillips screwdriver. Two of these screws will be
located on each side of the mount.
d. Remove the Right Sideplate.
e. Swing the Left Sideplate out and away from
the Base Extrusion. Removing the sideplates
exposes the mounting holes in the Base
Extrusion.
2d
Mounting Holes
3
ITEM(S) NEEDED
f.
Take the Electric Steer Quick Release Bracket
Assembly (Item #B and C) and remove the Pin.
Then open the Cam Lever and slide the Top
Plate away from the Bottom Plate until they are
separate. Set the Bottom Plate aside.
g. On the Top Plate, take note of the Cam Lever
attached to the plate. When the Top Plate is
attached to the Base Extrusion, the end with the
Cam Lever will mount on the same end the Power
Cord exits the base of the Mount.
NOTE:
The Cam Lever will only open and close in
one direction.
©2017 Johnson Outdoors Marine Electronics, Inc.
Right Sideplate
#B x 1
2c
2e
#C x 1
Top Plate
Bottom Plate
Sideplate Screw
Base Extrusion
Cam Lever
minnkotamotors.com | 3
Pin
Publicité
